Jan 26, 2017 10:38 AM
2549 Views
T’s ultimately the performance that matters most—a good feature set should ideally translate into pristine photo prints, crisp formation of text and flawless reproduction of colours and contrast, especially with a premium inkjet multifunction device such as this one.
Speed: The print speed isn’t exceptional, but just above average. On an average, it takes around 8 seconds to buffer the print job before it pulls in the first sheet and starts printing. The MG4270 printed 5 percent text document at 8 pages per minute(ppm) in both Fast and Normal mode. The only difference is the amount of ink used to print in the two modes; the latter is darker and crisper. With quiet mode activated, the speed drops to 5 ppm. The black and white text copying speed is about the same—it takes about 8 seconds to scan and buffer the page and then it prints at 9 ppm in fast mode. Colour copying is much slower. We copied a magazine page that had a mix of black text and colour photos. After scanning and buffering, it printed at 3 ppm in normal mode. So, if you copy a single page in colour, it will take around 40 seconds for the print to roll out from the time you press the Start button. Photo prints of 4×6 size is the slowest, because the focus is on print quality. In Standard mode, it takes around 50 seconds to print a borderless 4×6 colour photo, and the same job takes 1 minute and 43 seconds with the quality set to Best.
Quality: We started with text prints. The quality of text printing is very good if you use good quality paper(bond or alabaster paper). Even very fine text in 3 point size was legible.
